SAML21 can't program flash

All design tool related questions: compiler, assembler, linker. Embedded programming questions: assembler, C code.

Moderator: nferre

oualidoualialami
Posts: 1
Joined: Wed Jul 22, 2015 2:32 pm

SAML21 can't program flash

Thu Aug 04, 2016 12:09 pm

Hello everyone !

After making a prototype based on SAML21 board (SAML21J18B/WLCSP) I've encoutered a problem trying to program its flash (via SWD protocol using atmel-ice debugger).
I've been able to erase, but when I try actually programming it I receive the following message :

Code: Select all

Severity:		ERROR
ComponentId:	20100
StatusCode:	131103
ModuleName:	TCF command: Modules:writeToMemory failed.

Failed to write segment at 0x0 to target for memorytype base
Programming starts at address 0x0 and even after changing that address I keep having the same error message ( which seems to mean that I can't write anywhere on the flash ).
I hope that some of you have some insight ( or any hint really ) on this type of issue.
--

Cheers,
aarcov
Posts: 12
Joined: Thu Aug 18, 2016 3:26 pm

Re: SAML21 can't program flash

Fri Aug 19, 2016 4:59 pm

I would check to see if any lock bits are set and check to make sure I was using the latest firmware version.

Return to “Development Tools”

Who is online

Users browsing this forum: No registered users and 1 guest