I use Atmel Studio 6.2 (AS) for the SAMD20J18 on my XplainedPro evaluation kit (EK). Quite a lot SW for the final product is developed on the EK. Now I want to move to my target PCB, which has a SAMD20E17 MCU:
I entered the AS and did the following:
"Change Device..." + "Device Selection" --> "ATSAMD20E17" + OK.
I then got a pop-up message saying:
Atmel Software Foundation
ASF does not support device change since some of the existing modules in the project may not work.
I pushed the OK-button, saved my work and exit AS. Then I re-opend AS and I see (Properties + Device) that the MCU type is changed to "ATSAMD20E17" nevertheless !
Q-1: Can I trust AS so my code now really is compiled OK for the new/changed MCU type (ATSAMD20E17) ?
Q-2: If not, must I re-build my "kernel-SW" (include/collect all basic ASF's and manualy modifiy previous possible changes to these ASF/kernel-files), or is there another/smoother way to "move to target (with a slightly different MCU type)" ?
Best regards Terje Bohler
All design tool related questions: compiler, assembler, linker. Embedded programming questions: assembler, C code.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests