I am working on AT91SAM9263, along with AT91bootstrap and u-boot-2009.06
I built u-boot using following steps:
When I use the u-boot binary, the LCD screen become blank and also I didn't get anything on debug UART.
I am using at91bootstrap binary as it is available on linux4sam site.
Kindly request you to please tell me, if I need to set any extra things so as to build u-boot and use it?
Your remarks will be take into account in order to increase efficiency of this Forum: Helping the AT91 Community.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests