I am not sure if this should go in this forum.
:I have managed to get the NAND on the SAM4S XPlained Pro board to work. Reading a page takes about 600uS with non-optimized code, running at 120Mhz.
I know this has to be wrong and I am thinking I should be looking at how the EBI (SCM? ) is clocked? I am having a little trouble determining how that might be done.
I guess the main question is, how do I speed up the NAND read timing? And how do I determine the wait timings I use to set up the 29F that is on the board?