Page 1 of 1

sam4s xplained , example with sinewave generator

Posted: Tue Jul 07, 2015 4:12 pm
by barbonist
Hi all
, I want to try the example called dacc_sinewave_example1 , however , looking at schematics , it seems a 0 ohm resistor should be placed on J2.3 in order to get the signal going out. I have the schematic of the xplained board , but i miss the map of components on direct and reverse side , and no label is placed over there. Does anyone have the pcb components map in pdf format ?

thanks all .. Stefano