sam4s xplained , example with sinewave generator

Moderator: nferre

barbonist
Contact:
Location: italy
Posts: 2
Joined: Thu Jul 05, 2007 5:53 pm

sam4s xplained , example with sinewave generator

Tue Jul 07, 2015 4:12 pm

Hi all
, I want to try the example called dacc_sinewave_example1 , however , looking at schematics , it seems a 0 ohm resistor should be placed on J2.3 in order to get the signal going out. I have the schematic of the xplained board , but i miss the map of components on direct and reverse side , and no label is placed over there. Does anyone have the pcb components map in pdf format ?

thanks all .. Stefano

Return to “SAM9-based”

Who is online

Users browsing this forum: No registered users and 3 guests