Manual reset via JTAG instructions

Moderator: nferre

nikdaf
Posts: 2
Joined: Mon May 11, 2015 6:39 pm

Manual reset via JTAG instructions

Tue Jun 09, 2015 2:52 pm

Hello, I am trying to perform a manual reset of the SAMA5D3Xplained board via the JTAG interface.
The board needs to be reset by writing to a register in the DAP instead of using the usual reset input.
AFAIK I have to use DPACC and APACC accesses to write to debug registers as described in IHI0031C_debug_interface_as.pdf.
This debug register should be DBGPRCR, Device Powerdown and Reset Control Register, as mentioned in DDI0406C_C_arm_architecture_reference_manual.pdf
.What I do not know is which AP and which scan chain to select for the access to this register.
Is it the MEM-AP, and if yes, at which AP number do I have to access it (value in SELECT.APSEL)?
Thank You for Your help.

Return to “SAMA5-based”

Who is online

Users browsing this forum: No registered users and 3 guests