SAMA5D3 Xplained otg support

Moderator: nferre

roshin
Posts: 1
Joined: Fri Oct 31, 2014 11:38 am

SAMA5D3 Xplained otg support

Fri Oct 31, 2014 11:54 am

I am working with the SAMA5D3 Xplained.
Does SAMA5D3 Xplained support USB OTG through it micro USB port if its powered using the 5v barrel connector.
I am using kernel linux4sam(linux-3.15-at91 branch from git hub :https://github.com/linux4sam/linux-at91 ... -3.15-at91).I have see your application notes (atmel_11201_usb-otg-like-connector-implementation_sam9g-sam9x-sama5d3_application-note) but this for kernel 2.6.9 and i believe the driver has been modified after that. Is is possible to do the same with the newer linux4sam (linux-3.15-at91)?.
 
mwi
Posts: 25
Joined: Wed Jul 30, 2014 9:17 pm

Re: SAMA5D3 Xplained otg support

Thu Jan 29, 2015 12:33 pm

hi, i have the same question. want to use the sama5d3 as client, but i do not see anything in kernel messages (neither on laptop, nor on sama5d3) if plugging in OTG client cable.
bseljak
Posts: 28
Joined: Thu Apr 03, 2014 1:28 am

Re: SAMA5D3 Xplained otg support

Thu Jan 29, 2015 10:10 pm

Hi!
You should check usb gadget - this is kernel support for usb in device mode.
Borut 
mwi
Posts: 25
Joined: Wed Jul 30, 2014 9:17 pm

Re: SAMA5D3 Xplained otg support

Fri Jan 30, 2015 2:53 pm

hi, thanks for your response.

activated the USB gadget in kernel config already (using the serial com gadget for first try).

but nothing is happening.

I think that the port USBA is running in HOST mode on my machine and I do not see anything therefore.

Read inside the datasheet, that the multiplexer for the USBA PHY must be configured in some USB register. I will try next week.
mwi
Posts: 25
Joined: Wed Jul 30, 2014 9:17 pm

Re: SAMA5D3 Xplained otg support

Tue Feb 03, 2015 3:14 pm

a quick note.

I just received my XPlained board. there USBA seems to be set to device mode by default.

Worked on a SAMA5D33EK before, where this seems to be different. I will continue to check.
sjcchuma
Posts: 17
Joined: Tue Oct 07, 2014 11:05 pm

Re: SAMA5D3 Xplained otg support

Tue Feb 10, 2015 8:58 pm

Has anyone able to get OTG working?

Return to “SAMA5-based”

Who is online

Users browsing this forum: No registered users and 2 guests