no valid processor id after errormoues flash erase

Discussion around products based on ARM Cortex-A5 core.

Moderator: nferre

anniyan_x
Posts: 1
Joined: Wed Nov 20, 2013 3:09 am

no valid processor id after errormoues flash erase

Wed Nov 20, 2013 4:36 am

hi

after not successfully making sam-ba to connect to the sam5d3x kit in Linux host pc, then I decided to use windows to connect sam-ba to the kit. it worked, and I can connect to the board, but because of my carelessness I accidently erased the nand flash without giving the correct address on memory download area, after that I also did same thing on the spi dataflash too by accidently not clicking nandflash tab.. later I off everthing and my board cant boot (sure it can boot as I erased ady) but now I just wana load back everthing into the board again.. but I get no valid processor id found if I try to connect, but I can connect is I choose "no board" on the sam-ba..

how to go about this?? how load back everthing back into the nandflash.
CptTitanic
Posts: 871
Joined: Sat Oct 30, 2010 6:04 pm

Re: no valid processor id after errormoues flash erase

Wed Nov 20, 2013 5:40 am

How have you attempted connectivity? Serial, USB, JTAG?

Return to “SAMA5D Cortex-A5 MPU”

Who is online

Users browsing this forum: No registered users and 1 guest