Any patch file is available for Samsung nandflash k9f5608 timing support in samba v2.11 application,kindly update this patch.
Microchip in-system programming solution: SAM-BA
2 posts • Page 1 of 1
I am using the SAM3S1B processor. I want to use the ROM bootloader communicating via the USB port. To enter the bootload mode from my application I clear the GPNVM bit 1 and then reset the processor with a software reset. No other action is taken. The device appears to go into the boot mode. However, I cannot communicate and when I check the enumeration using USB View I see that it has not enumerated. Is there something I'm not doing? Any ideas out there? Thanks.
Who is online
Users browsing this forum: No registered users and 1 guest