Hi everybody! I just install sam-ba v.12.04 for Linux and it don't run.
Follow the README.linux from the installation folder. When go to step /4 from the installation proccess and execute the command lsusb -d 03eb:6124 there was no answer on it.
Also check the dmesg with the command:
# dmesg | grep usbserial
[ 2585.478620] usbcore: registered new interface driver usbserial
[ 2585.478656] usbcore: registered new interface driver usbserial_generic
[ 2585.478658] usbserial: USB Serial Driver core
[ 3637.039916] usbcore: deregistering interface driver usbserial_generic
[ 3637.039960] usbcore: deregistering interface driver usbserial
[ 3656.416739] usbcore: registered new interface driver usbserial
[ 3656.416776] usbcore: registered new interface driver usbserial_generic
[ 3656.416778] usbserial: USB Serial Driver core
[ 4383.522669] usbserial_generic 1-5:1.0: Generic device with no bulk out, not allowed.
[ 4383.522678] usbserial_generic: probe of 1-5:1.0 failed with error -5
[ 4383.522735] usbserial_generic 1-5:1.1: generic converter detected
Note that after installation point I do also and the notes for Ubuntu. But there write that it's not tested with my Ubuntu version.
When try to launch the sam-ba with connected board from console it don't find it. When I try to launch sam-ba from the executable at the folder the start window appear but there is no connection available.
Any ideas how to make sam-ba works on my Ubuntu?
Microchip in-system programming solution: SAM-BA
2 posts • Page 1 of 1
Sorry, my colleague helps me. I was forgot to connect the board before do the things in the README.linux. Now SAM-BA 2.12 works for me
Who is online
Users browsing this forum: No registered users and 2 guests