Our design is based on the 9263 eval board, and supports either 8 bit or 16 bit Nandflash. The 8 bit part works fine, but when the 16 bit part is soldered in and I Enable Nandflash in SAM-BA, I get:
Script Error: Can't detect known device
The device ID is in the list in NandFlashModelList.c, so shouldn't it be recognized? Do I need to edit a script or recompile an applet? Or is it likely to be a hardware problem?
Detecting 16 bit Nandflash
Post
Re: Detecting 16 bit Nandflash
In case anyone else has this problem, I found out from Atmel tech support that this is a hardware issue. The pinouts for the 16 bit Micron flash changed radically between rev AAC and AAD. We were able to jumper the changed lines and make it work.
Who is online
Users browsing this forum: No registered users and 1 guest