How to change 32bit SDRAM to 16bit on 9260EK, with WINCE6?

This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.

Moderator: nferre

redroof126
Posts: 1
Joined: Thu Oct 18, 2012 4:26 am

How to change 32bit SDRAM to 16bit on 9260EK, with WINCE6?

Thu Oct 18, 2012 10:11 am

I want to design a board based on 9260EK. For minimize the board size, I want to use only 1 chip SDRAM(MT48LC32M16A2, 32M*16bit) other than the original (MT48LC16M16A2, 16M*16bit *2chip).

Do I need to modify the FIRSTBOOT_NAND.nb0?(I use NAND flash to boot )
Or do I need to modify the EBoot?
Or do I need to modify the WINCE BSP?
CptTitanic
Posts: 877
Joined: Sat Oct 30, 2010 6:04 pm

Re: How to change 32bit SDRAM to 16bit on 9260EK, with WINCE

Sat Oct 20, 2012 2:41 pm

windows4sam/bin/view/Windows4SAM/GettingStarted

Going to be in FirstBoot, the equivalent to AT91BootStrap for Linux. On the 9260 this will be a small 4KB loader which resides in block 0 of NAND, runs in SRAM, and configures the geometry of the SDRAM (ie chip rows, columns, timing and bus width), before loading the next stage into SDRAM.

Isn't the 9260 a bit old for a new design?

Return to “WinCE”

Who is online

Users browsing this forum: No registered users and 1 guest