Page 1 of 1

PPP through serial port on customized AT91SAM9260 board

Posted: Fri Dec 16, 2011 4:49 pm
by psupina
Hello,

I am trying to establish a PPP connection from my customized AT91SAM9260 board to a remote PPP server (using GUI through the remote display application) - but this process hangs up.

Does anyone here accomplished to create a PPP (or GPRS) connection on AT91SAM9260 board?

I would be glad to get more information on this topic.

Thank you.

Best regards,
Peter

Re: PPP through serial port on customized AT91SAM9260 board

Posted: Mon Dec 19, 2011 8:15 am
by sandeepsiv
Hii psupina, now i am working with AT91SAM9XE512. I was established a tcp/ip connection with the public ip of our server PC through GPRS connection. i am also using the freertos in my project.

Re: PPP through serial port on customized AT91SAM9260 board

Posted: Tue Dec 20, 2011 12:11 pm
by psupina
Thank you for your response, sandeepsiv.

How did you configure serial port driver to show up in the "Network Connections" -> "Make New Connection" wizard?

When I just include the USART device drivers from the Catalogue, these serial ports don't show up in that wizard.
So I needed to add some registry settings for Unimodem for these ports.

Or is there other way to establish GPRS connection via modem listening on serial port?

Thank you.

Peter