Compile Adeneo Drivers - Debug mode

This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.

Moderator: nferre

adamax
Posts: 9
Joined: Fri Apr 02, 2010 2:56 pm

Compile Adeneo Drivers - Debug mode

Mon Apr 26, 2010 4:06 pm

Dear all,
I have just made a change in Adeneo's serial driver and run build in debug mode (configuration manager--->debug).

I have find out that new .obj has been produced in the retail folder

C:\WINCE600\PLATFORM\COMMON\SRC\SOC\ATMEL\COMMON\DRIVERS\Serial\obj\ARMV4I\retail

while I was expecting it to be generated in debug folder

C:\WINCE600\PLATFORM\COMMON\SRC\SOC\ATMEL\COMMON\DRIVERS\Serial\obj\ARMV4I\debug

My question: is there anything I shall do to have drivers in debug mode, beside choosing "debug" from platform builder?

Any change in make file?


Thanks
Regards
Adeneo
Contact:
Location: France - USA
Posts: 183
Joined: Fri May 14, 2004 9:58 am

Re: Compile Adeneo Drivers - Debug mode

Mon Jun 21, 2010 11:57 am

Hi adamax,

Normally it works well.
Please ensure to build the driver after changing the build type.

HTH

Return to “WinCE”

Who is online

Users browsing this forum: No registered users and 2 guests